A Boss inspired slicer effect using a sample file to create the patterns.
It’s a very simple patch. Mono audio in / stereo out.
Incoming audio follows the amplitude of the sample file using an envelope follower and a vca.
Any sample can be used but this was made with a 2 minute 40 second (20 pattern samples at 120 BPM) mono sample file recorded using the original patterns of Boss GT-10 multieffect.
The main interface is a 20-key KEYBOARD to select the Boss pattern (P1-P20). Each pattern is two bars long as in the original (I just realised that I didn’t really check…)
Yellow RATE CONTROL changes the rate of the slicer effect.
Left STOMPSWITCH turns the effect on and off.
This was just a quick test so there’s room for improvement. When incoming audio gets really low there may be some stuttering audible in the pattern.
The main interface could be a lot nicer. The middle and right stomp switcher could select the patterns. There could be some adjustment for the envelope attack / release. Add a reverse function. And so on.
For those who know about the Boss, the patterns were sampled from the original Boss GT-10 using a Trigger sensitivity of 50 with a square wave from ZOIA. Changing these values might improve the effect.
BEWARE!!! The sample file is LOUD. It’s not meant to be listened to.

Oh, just noticed that the RIGHT OUTPUT is not connected to anything. Well, you’ll figure it out.
Also note that if you want to use any other sample file you naturally have to map the keyboard accordingly to move the starting point of the samples. And probably change the length as well. This patch assumes a lot. The sample file should have 20 two-bar samples at 120 BPM with two bars (of silence) in-between.
This is super cool! I love the idea of capturing those classic Boss patterns. It sounds like a fun experiment, and even with the current limitations you mentioned, I bet it opens up some really creative possibilities. It reminds me a bit of how much you can build and discover in Infinite Craft .