Insert Mode Program. Series Routing (default), and something noticeably missing from the optional Parallel Routing. Program MIX 50%. Sticky Tape into TremoloPan, with stereo use in mind.
Doubling effect on warped vinyl, creating a deep Doppler, pulsating & panning through a very thin atmosphere. Exceeding the dosages recommended here may cause dizziness, leading up to spatial disorientation. Variable foot control over both modulation rates, depths of effect, delay time and pan positions, and/or add secondary modulation influences.
EXP1 sweeps Offset, W&F Amount & Rate and Width in Sticky Tape with Depth, Speed & Width in TremoloPan. A light foot action will give the warping some time to settle down. More rapid movements evoke heavy whammy bar bends.
EXP2 is mapped to the [B] HotKnob parameters below. It will also decrease Flange Length in Sticky Tape while increasing TremoloPan Mod Rate & Manual Mod. Both expression pedals are saved at Heel.
HotKnob mappings, for making these parameter adjustments:
* [P] HotKnob (+/-) adjust Sticky Tape / Speed + Drive/Edge in TremoloPan. [default = 29]
* [A] HotKnob (+/-) adjust Sticky Tape Compression & Rec Drive. [default = 75].
* [B] HotKnob (+/-) increase Depth & Speed Mod in TremoloPan. [default = 0 or EXP2]
* MIDI CC# 1 TremoloPan Shape
* MIDI CC# 2 TremoloPan Mod Source
* MIDI CC# 3 Sticky Tape Gate Thresh
* MIDI CC# 8 Sticky Tape Mix
* MIDI CC#74 Sticky Tape Filter
* MIDI CC#82 TremoloPan Type
Performance techniques:
* Latching or momentary FLANGE.
* TremoloPan BRAKE/SPEED [default = FAST]
* HS1 – add stacked distortion with bias tremolo.
* HS3 – add stacked distortion with chopping bias tremolo.
See the Program Notes for more information on the PERFORM switch mappings.