Disclaimer: I use the beebo after my ampsim so some adjustment may be needed for the threshold if used in front of amp.

I guess this has been done already many times but I wanted to share my take on it. None of the modules really need a manual, so it’s an easy one to start off with.

Saturator (could be replaced with the warmth module too) into auto swell. Then it’s split into a HPF, a delay, and a reverse.

The HPF goes into the reverb and goes directly into the final wet/dry.
The delay goes into a wet/dry to mix with the auto swell signal.
The reverse goes into another delay and they both mix into another wet/dry.
These two wet/dry go into yet another wet/dry, and into the doppler panner, to finally mix with the reverb and into the outs.