Base Program
* Triple layer tremolos: 3 offset entrances, at 3 sync’ed rates, over a 3 register spread.
* Slow down, smear & reconfigure the variations with switches & pedals.

* Insert Mode Program. Program Mix at a wet 60%. Adjust for prominence of effect.
* TremoloPan into Cosmic Web. Optional Parallel routing washes out the chopping.
* All controls programmed for an interactive approach.

HOTKNOBS
Program [P] HotKnob – default (96 OR CC#40)
* Secondary control over fading the granular components in & out.
* Shapes the tremolo waveforms.

Preset [A] HotKnob – default (50 OR CC#12)
* Adjust the modulation waveshape through envelopes & manual (EXP1).

Preset [B] HotKnob – default (0 OR CC#79)
* Increases regenerations around the upstream effects.
* When used as a looper, DUMP resets the loop input.

PEDALS
EXP1 (saved @ full Heel)
* Decreases initial tremolo rate with manual modulation.
* In conjunction with 1/8th speed & braking Performance switch.
* Collapses detuning depths to zero while widening the primary panning.

EXP2 (saved @ full Heel)
* Increases tremolo frequency modulation with reverb level.

SWITCHES
* AUX 0 = default
* AUX 1,2,3 mapped to HS1, HS2, HS3 (momentary)
* AUX 4,5,6 mapped to HS1, HS2, HS3 (latching)

Program Alternates
0). Modulated dry, octave up & octave down, heavily sliced, singular delays.
1). Distorted dry burst, octave down + 5th cascade, medium delays, decaying repeats.
2). Smoother randomized peaks, all unisons, short delays, moderate fade.
3). Overdrive dry, octave & 2 octaves up, chopped ramping, long delays, slight repeat.

PERFORM
1). [P] Act/Byp
2). T/P RETRIGGER (CC#83)
3). C/W RETRIGGER (CC#83)
4). TAP: 100 BPM
5). BRAKE/SPEED
6). HS3 [L]

See the Program Notes for specifics on external control parameters & MIDI mappings.