Hey everyone,

Use your Zoia stomp switches with 2 functions. Single and double press.

Limitations:

– Single press switch is delayed by however long you set the delay + some internal delay.
– Single press can never be closer together than the delay length.
– While the delay line is hot you can not use other switches (base setting is 200ms)
– Any pedal presses after the double press will be filtered out

Page 0 is the effects page. The bottom row is the outputs from the single/double taps. If you want to build your own effects just move the bottom switcher and clear page 0.

Bottom switcher is laid out as followed:

Output 1 = left switch single click
Output 2 = middle switch single click
Output 3 = right switch single click
Output 4 = left switch double click
Output 5 = middle switch double click
Output 6 = right switch double click

Default setup is:

Output 1 = distortion
Output 2 = chorus + delay
Output 3 = distortion + chorus + delay
Output 4 = distortion + reverb
Output 5 = chorus + delay + reverb
Output 6 = chorus

Page 1 and 2 are the all the logic stuff required. Mind that there’s only 1 switching circuit to keep this patch light. This means your SHOULD NOT press different pedals within the delay lines time setting (default 200ms, set this on page 1 under “M”. 300-400 recommended for use with your feet.). So for instance pressing left and middle within 200ms of each other will probably break things… but that’s on you ;)

Feel free to use this in your patches. If you publish patches with this circuit please attribute, that’s all I ask for.