This is a 5 band EQ that has an A/B switch (dry/wet) and a looper so you can sample a bit of audio while you work on the EQing.
The 5 “bands” are located on the left side of the main page. In order of appearance:
(these can be easily changed. Just make sure the outs/ins are hooked up)
Blue: LOW PASS
Green: HIGH SHELF
Yellow: BELL
Orange: LOW SHELF
Red: HIGH PASS
The A/B switch is located at the top-right of the main page. WHITE=dry/loop signal
BLUE= EQ/loop signal
The looper controls are located at the bottom-right. The RED button starts/stops the looper when it is pressed.
The GREEN button next to the start/stop button is for recording the loop. It turns RED (record) while it is pressed and the looper only records while it is pressed/held down.
On the right side of the middle row there is a PURPLE value module which is meant to balance the dry/wet signals for comparison with the A/B switch.
I’ve also included a simple VU meter for good measure :)
Huge thanks for this! I can fine-tune my Microfreak now :D