Insert Mode Program. Configured for Series (default) or optional Parallel Routing. Program MIX 40-50% (via EXP1). Reverse Reverb into UltraTap. Programmed for stereo use.
Base Program is a medium room reverb, with a slightly metallic Quonset Hut vibe. Foot control brings longer multi-tap delays, tremolo & pitch modulation, reduced smearing, plus a 2nd reverb with increased length of decay, sampled reflections & more tapped positions.
This Program shines best while using one or two expression pedals … expressively. EXP1 sweeps Program Mix with the [P] HotKnob parameters listed below. EXP2 (optional) increases Reverse Reverb’s forward reverb Size to Infinite, and changes UltraTap Taps and Taper (saved at Heel).
All three HotKnobs are pre-programmed for making fine adjustments to several of the effects. Customize the sound, using these variations:
* [P] HotKnob (CW-EXP1) – change Reverse Reverb Decay, Feedback, Diffusion, Mod Level, with UltraTap Length, Pre Delay, Manual Chop, Speed and Width [default = 0-Heel]
* [A] HotKnob (+/-) – adjust Late Dry & Contour in Reverse Reverb [default = 75].
* [B] HotKnob (+/-) – adjust UltraTap Chop type & Speed-Rise-Release [default = 15].
* MIDI CC#8 both Reverse Reverb & UltraTap Mix
* MIDI CC#12 Reverse Reverb Low + High Level
Momentary or latching Infinite & Freeze in Reverse Reverb. Latch either one (or both) with expression pedal movements. HS1 (M) momentarily kicks Feedback to 100 in both FX blocks.
See the Program Notes for more information on the PERFORM switch mappings.
Mods, thank you for the housekeeping.