CBA MOOD emulation with Marbles.

It reminds me of the Eventide H9/TimeFactor looper, too. So, it’s pretty much both but leaning towards MOOD.

Basic stuff:

1) Footswitch A & B triggers Freeze in Looping Delay and Granular modules.

2) For the Marbles, you can just add/remove it accordingly to free up some DSP load. Or route the CV outs to a different parameter that is most useful for you.

3) I did not add a reverb module on purpose because I use a separate reverb pedal.

4) The Delay modules can be used independently or to interact with the Granular and Looping Delay modules. I routed them specifically to feed the other modules, which is what I need.

Performing:

1) I usually play around with the tape length and pitch windows of the Looping Delay module. Marbles can manipulate either of these parameters.

2) I set the pitch of the Granular module either at -7 or -15 when playing on a higher key, around +4 to around +7 on a lower key; for Looping Delay, it’s pretty much a hit-or-miss: if it sounds good, that’s where I’ll work from.