BOOM Warmer

This is a stereo warming / distortion effect for Drambo inspired by the OTO BOUM Warming Unit. This patch includes an easy-to-use compressor/gate, a multi-mode distortion generator, low-pass and high-pass filters, and a wet / dry mixer.

INPUT LEVEL: This controls the signal going into the patch. The conpressor’s threshold is effected by this knob; however, the gate is not effected.

GATE: Turning this knob clockwise will gate the sound. This can be used to control noise or for creative sonic mangling.

COMP: Turning this knob clockwise compresses the sound. At high levels the compressor’s gain reduction overshoots and caused ducking of loud peaks.

LOW CUT: A 6dB/Octave high pass filter, pre-distortion.

DRIVE: Simultaneously controls the input gain and output volume of the distortion generator.

DISTORTION: Press the button to cycle between the four distortion modes: 1) Boost: subtle warming and soft distortion, 2) Tube: asymmetrical distortion, 3) Fuzz: hard clipping distortion, 4) Square: comparator-based total square wave annihilation.

HIGH CUT: A 12dB/Octave low pass filter, post distortion.

LEVEL: Sets the output level before the Wet/Dry Mixer.

MIX: The wet/dry mixer. This controls the balance between dry and effected signals.

3 comments on “BOOM Warmer
  • Bcrichards on said:

    Wow! You’ve packed so much in to such a cleanly packaged module. Thank you.

  • jameslondon74 on said:

    Drambo crashes when I load this. Any idea why?

  • Gat on said:

    Brillant job.
    I put it on the master and BOUM 😊😋
    If I want to use an external source for side chaining at which stage do you recommend to place the it?

  • Leave a Reply

      1123 PM
    • Platform:
    • Category: Effect
    • Revision: 1.0
    • License: MIT License
    • Modified: 4 years ago
    • Views: 166
      Likes: 3
      Downloads: 55
    Download
    Chat