Instructional Preset. A Phase generator is sent into four filters (low pass, high pass, bandpass, band reject (notch) with a master Cutoff Frequency and Bandwidth control that applies to all. Separate output controls allow you to bring in each of the filtered outputs or any combination.

Instruction. No use of Y so will not do anything in the Aftertouch area of Osmose. Try changing to any filter type and adjusting cutoff and bandwidth to experiment. Also change the filter cascade from 1 to any of the other three options to hear what that does (some will be very subtle).

Macro Controllers:
i = Cutoff (Controls cutoff frequency from 40Hz to 40kHZ). Applies to all filters.

ii = Bandwidth (Changes bandwidth from 0.05 to 1.0) Applies to all filters.

iii = Filter1Amt (Controls amount of Filter1 output). Set minimum for no output from that filter. Defaults LFP (Filter1) on.

iv= Filter1Amt (Controls amount of Filter2output). Set minimum for no output from that filter.

v = Filter1Amt (Controls amount of Filter3 output). Set minimum for no output from that filter.

vi = Filter1Amt (Controls amount of Filter4 output). Set minimum for no output from that filter.

Surface
X = Pitch
Y = Not used
Z = Volume

Ped1: Sus
Ped2: Sos1