Base Program
* Experimental creation station: Loopers, multi-taps, grains & resonators.
* Destructive / non-destructive controls & modulations, routing-dependent.
* ‘Always on’ recording, until interrupted by one of the methods below.

* Insert Mode Program. UltraTap into GrainMod for choppy results.
* Smoother transitions in the optional Parallel routing.
* Program Mix = 50%. Tap Mix = 75%. Grain Mix = 75%.

HOTKNOBS
Program [P] HotKnob – default (100 OR CC#72)
* Destructive manipulation & chaos controller.
* CCW – (wipe) to tunable resonators.
* midrange – multi-taps & medium delays.
* CW – longer echoes & tap loopers.

Preset [A] HotKnob – default (100 OR EXP1)
* Resonator & loop decay control.

Preset [B] HotKnob – default (100 OR (P) HotKnob)
* Separated control over the duration of grains.

PEDALS
EXP1 (saved @ full Heel).
* Increases all modulation rates & decay of loop-tap-resonator.
* Serves as a longer duration ‘erase’ & fader over old/new events.

EXP2 (saved @ full Heel)
* Increases diffused modulation, reverb & directional grain rate.

SWITCHES
* AUX 0 = default
* AUX 1,2,3 mapped to HS1, HS2, HS3 (momentary)
* AUX 4,5,6 mapped to HS1, HS2, HS3 (latching)

Program Alternates
0). 6-tap long looper – zero loop decay – SAW chop – +REV+ – HP filter.
1). 8-tap delay scramble – hefty decay – SQR chop – +FWD+ – LP filter.
2). 16-tap crescendo chop – light decay – trig env – all FWD – HP filter.
3). 64-tap smear wash – 100% loop decay – swell env – all REV – HP filter.

PERFORM
1). [P] Act/Byp – freezes effect input to loop – dry signal overlay.
2). TAP (A) – master control over length & mod rate, env rise, release.
3). TAP (B) – master control over grain delay & all modulation speeds.
4). HS1 [L] – longer disintegrating ‘erase’ function.
5). HS2 [L] – slowest development of ‘erase’ function.
6). HS3 [L] – fastest ‘erase’ function, not instantaneous.

Program Notes have more specifics on external control parameters & MIDI mappings.