Base Program
* Independent delay shifters, detuned & panned to engageable long loops.
* [P] HotKnob cross-mixes dual delay times with maximum loop lengths.
* TAP:20-500 BPM sets relative scaling over all delay & looping effects.
* (Not a 12-bit exact replica, @ellacoolj, inspired by & expanded upon).

* Insert Mode Program. Polyphony into Looper.
* Non-destructive pitch-shifting option in Parallel routing.
* Non-destructive loop pitch-processers in swapped Series routing.
* Program Mix = 100%. Polyphony Mix = 50%. Looper Mix = 50%.

* Bypass (P) / CC#85 continues with dry over looping.
* Bypass (A) / CC#86 & #104 solos the looper section.
* Effectively in “bypass (B)” until REC is first engaged.
* Dual delays locked by FREEZE, modulatable by pitch sweeps.

HOTKNOBS
Program [P] HotKnob – default (76 OR CC# 89)
* Macro control over short-long delay to long-short loop cycles.

Preset [A] HotKnob – default (50 OR EXP1)
* Sets pitch intervals above & below unisons.

Preset [B] HotKnob – default (0 OR CC# 90)
* Determines looper playback speed & direction.

PEDALS
EXP1 (saved @ full Heel).
* Narrows detuning, widens panning.
* Glides through to [-1/+1] octave spread.

EXP2 (saved @ full Heel)
* Increases delay feedback alongside rising looper decay.
* Flips looper start & end points: slicing & stutter FX.

SWITCHES
* AUX 0 = default
* AUX 1,2,3 mapped to HS1, HS2, HS3 (latching)
* AUX 4,5,6 mapped to REC – PLAY – STOP.

Alternate Loopers
0). Unisons – medium offset delays – latched overdub – directional reverse.
1). Low octave & 5th – short delays – punch-in replace – one-shot trigger.
2). High octave & 5th – long delays – latched replace – auto-loop speed drop.
3). 5th & octave up – dotted bell-trees – punch-in replace – loop trigger.

PERFORM PAGES
1). [P] Act/Byp
2). FREEZE [L]
3). 1-BTN LOOP

4). TAP: 100 BPM
5). HS2 [L]
6). SPEED

7). RECORD / OVERDUB
8). PLAY (reverse, retrigger, reset)
9). STOP / ERASE (hold)

Program Notes have more specifics on external control parameters & MIDI mappings.