III Stomp is a patch template that allows you to have three effects in parallel, assigned to each stompswitch of the ZOIA.

Firmware 2.0 needed! Performance mode must be engaged.

Page 1: Here you have audio I/O (mono in – stereo out), Cab simulation and tone control with two mid bands. You also have a 2×2 indicator that switches from blue to green when one effect is engaged (I chose these because I’m deuteranopic, you can change them if you want).

Page 2: the brain of the effect, here you have the value modules that take care of the colour selection. on the upper side you have the signal switching section (if you want to change the effects you will need to connect the audio in switch output to the input of your chosen effect module, then the effect output to the audio out switch output).

Page 3: Here you have the three effects I chose, but you can use them to inspect where the audio is going in case you want to change them.

The pitch-shifter is between the audio out switch output and the cab sim module.

It’s a patch that fits my needs but I think will adapt to those who need a simple interface for switching between three different effects.

Widely used on my latest album of 366-songs :)